Сообщение на Cisco 2600

[MartishinAE Профиль Сайт]

Доброго времени .

Вот такое сообщение появилось на маршрутизаторе при изменении c half-duplex на duplex.
Если кто-то разбирается просьба прокомментировать .


2w4d: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not
half duplex), with api-elevator-s1. fec0 (half duplex).

[Harry33 Профиль СайтICQ]

MartishinAE
sh int fa0/0 в студию плиз

[Harry33 Профиль СайтICQ]

Harry33
speed auto стоит?

[MartishinAE Профиль Сайт]

#sh int fa 0/0
FastEthernet0/0 is up, line protocol is up
Hardware is AmdFE, address is 000d.2849.b2a0 (bia 000d.2849.b2a0)
Internet address is 192.168.100.50/27
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 11000 bits/sec, 2 packets/sec
5 minute output rate 4000 bits/sec, 3 packets/sec
2957981 packets input, 1316219129 bytes
Received 920438 broadcasts, 0 runts, 0 giants, 0 throttles
75 input errors, 75 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
2503318 packets output, 286341157 bytes, 0 underruns
0 output errors, 610 collisions, 4 interface resets
--More--
2w5d: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not
half duplex), with api-elevator-s1. fec0 (hal 0 babbles, 0 late collision,
4310 deferred
24 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out

[PavelKHTW Профиль]